Shutting Down; Cleaning, Care And Maintenance; What To Do If - AEG WKL 753 S/U Bedienungs Und Installationsanleitung Handbuch

1 Pin
2 Temperature selector
» To limit the temperature setting range, set the minimum and maximum values at the temperature selector, and push
a pin for each into the slightly offset hole opposite (see diagram).
1 Pin
2 Temperature selector
4.4

Shutting down

» Move the switch on the right of the appliance to OFF.
5.

Cleaning, care and maintenance

If a pale brownish discolouration appears on the appliance casing, wipe this off as soon as possible with a damp cloth.
Clean the appliance when cold with ordinary cleaning products. Avoid abrasive or corrosive cleaning products.
CAUTION Fire
Never spray cleaning spray into the air slot.
Ensure that no moisture can enter the appliance.
As part of regular maintenance, we recommend also having the control components checked. The safety and control
components should be checked by a contractor no more than ten years after commissioning.
6.

What to do if ...

... the appliance does not heat up:
Check the temperature set at the appliance and the MCB/fuse in your fuse box.
The appliance has a safety temperature controller that shuts the appliance down if it overheats. After the cause has been
removed (for example air outlet or inlet apertures covered) and the appliance has cooled down for a few minutes, ope-
ration starts again.
If you cannot remedy the fault, contact your contractor. To facilitate and speed up your enquiry, please provide the number
on the type plate (no. XXXXXX - XXXX - XXXXXX):
2
1
1
2
1
1
Operation
19