Alarm Setting - BEARWARE 303530 Kurzanleitung

8.3 Alarm setting

The weather station can store up to 2 alarm settings, which can be turned on and
off separately.
Setting the alarm
1. Press the "MODE" button two times in the default screen to access the
alarm mode. Only the alarm time is shown in the display.
2. Press and hold the "SET" button in alarm mode for 2-3 seconds until the
alarm time starts to flash.
3. Press the "UP" and "DOWN" buttons to configure the values. Confirm the
entry using the "SET" button. Once you have configured ALARM 1, you have
to configure ALARM 2 as well. Confirm your entry again by pressing the
"SET" button.
Enabling the alarm
Press the "ALARM" button in the default screen. An alarm icon is subsequently
displayed above the current time. This means that the alarm is turned on. To
disable alarm 1 and to enable alarm 2, press the "ALARM" button again. Pressing
the "ALARM" button again enables alarm 1 and alarm 2. Both alarm symbols are
shown in the display.
Both are disabled by pressing the "ALARM" button again. The symbols then
disappear from the display.
Switching off the alarm
The alarm is activated at the configured time. The alarm is active for 2 minutes
and 30 seconds before it turns off automatically.
Press the "SNOOZE/LIGHT" button to cancel the alarm. If a snooze symbol is
shown on the display, this means that the snooze function is activated and the
alarm will go off again in 5 minutes.
Press any button to switch off the alarm.
26
English