Temperature Alarm - BEARWARE 303530 Kurzanleitung

8.2 Temperature alarm

It is possible to define a temperature range for the outdoor sensor and for the
indoor temperature. With the temperature alarm, the base station will sound an
alarm if the reading is outside this temperature range.
1. Press the "MODE" button 4 times consecutively in the default screen, so
that only the indoor and the outdoor temperatures are displayed. Then
press and hold the "SET" button for about 2-3 seconds until the tempera-
ture to be configured starts flashing.
2. Then press the "UP" or the "DOWN" button to select the minimum tem-
perature of the desired range (LO). Confirm the value by pressing the "SET"
button.
3. You can then select between "ON" and "OFF". This selection option
determines whether the corresponding alarm should be switched on or off.
Confirm your selection using the "SET" button.
4. Then press the "UP" or the "DOWN" button to select the maximum tem-
perature of the desired range (HI). Confirm the value by pressing the "SET"
button.
5. You can then select between "ON" and "OFF". This selection option
determines whether the corresponding alarm should be switched on or off.
Confirm your selection using the "SET" button.
6. After configuring the outdoor sensor, you can define the newly configured
values for the indoor temperature as well. Repeat the previous steps for
the indoor temperature for your desired temperature values.
If the outdoor sensor measures a temperature outside the previously configured
range, an alarm is emitted for about one minute from the base station. This alarm
can be muted by pressing a button on the weather station. The temperature
which triggered the alarm will start flashing in the display.
To turn off the temperature alarm, go to the temperature alarm settings. After
selecting the temperature for the corresponding alarm, you must select "OFF"
(see above, paragraph 3).
English
25