Alarm Setting - BEARWARE 302670 Bedienungsanleitung

• Year
• Month
• Day

9.1 Alarm setting

The weather station can store up to 2 alarm settings, which can be turned on and
off separately. By pressing the "SET" button you can view the configured alarm
times. You can turn the alarm times on and off using the "ALM" button.
Setting the alarm
Press the "SET" button to view the alarm times. Press and then hold the "SET"
button to change the corresponding alarm time. You can make the desired set-
tings using the "UP" and "DOWN" buttons. Confirm the settings respectively using
the "SET" button. You can configure these settings using Alarm 1 (A1) and Alarm
2 (A2). The alarm times of alarm 1 refer only to weekdays (Mon-Fri). The alarm
times of alarm 2 refer only to weekends (Sat-Sun).
Turning the alarm on and off
After successfully setting the alarm, the respective alarm times can be turned on
or off using the "ALM" button on the back of the device. The corresponding alarm
is turned on as soon as the corresponding symbol (alarm 1 or/and alarm 2) is
shown in the display.
Muting the alarm
When the alarm is activated at the configured time, the backlight also turns on
automatically. The alarm is active for 2 minutes before it turns off automatically. If
the alarm does not turn off within these 2 minutes, then it repeats automatically
after 24 hours.
If the "Snooze/Light" motion sensor detects a movement, then the alarm stops for
5 minutes before going off again. If the corresponding alarm symbol starts to flash
this means that the snooze function is activated and the alarm will go off again in
5 minutes.
20
English