BEARWARE 303530 Kurzanleitung Seite 27

9. Stored data
Maximum and minimum temperatures
Press the "UP" button to view the maximum indoor and outdoor temperatures as
well as the maximum humidity. "max" appears on the display. Press the "UP" but-
ton again to view the minimum measured values. "min" appears on the display.
After about 15 seconds, the current reading is displayed.
Note: The min/max temperatures are measured from the total operating time of
the weather station. Press and hold the "UP" button for about 3 seconds to delete
the stored maximum/minimum values.
Atmospheric pressure
The atmospheric pressure is automatically measured every hour and shown in the
display. The table shows the approximate trend of the atmospheric pressure.
10. Additional settings
14 day Learning mode
Whenever you do an electrical reset (remove batteries from the battery com-
partment and disconnect the mains adapter), the weather station will switch to
a 14-day learning mode to ensure a more accurate weather forecast trend. As
long as the weather station is in the learning mode, "Learning ..." is shown in the
display above the weather forecast.
Receiving the outdoor sensor signal
The outdoor sensor sends a signal twice per minute, which is automatically
received by the base station. You can also manually enable the signal reception.
Press the "CHANNEL" button repeatedly until you reach the channel that was se-
lected using the switch in the battery compartment of the corresponding outdoor
sensor. Alternatively, you can also activate the automatic channel switching. Here,
the weather station switches through all the channels, even through the ones not
used by the external sensors.
27
English