BEARWARE 303530 Kurzanleitung Seite 20

5. Initial use
Take the product out of the package and remove all the packaging material. Open
the battery compartment of the outdoor sensor and insert two 1.5V AAA batteries
and select the desired channel at the "Channel switch." Then open the battery
compartment on the back of the main unit and insert three 1.5V AAA batteries. Al-
ternatively, you can use the supplied coaxial power adapter for operation. For this
purpose, plug the mains adapter into a properly installed socket and then connect
it to the coaxial connector of the main unit.
Note: If you want to use the device with batteries, then the backlight is
not permanently switched on. The backlight of the display is continuously
switched on only when operated with the enclosed power adapter.
The weather station then attempts to establish connection with the outdoor sen-
sor. Ensure that both devices are within each other's range. The connection symbol
" " flashes in the "Outdoor temperature display" of the main unit. If the main
unit cannot establish a connection with the outdoor sensor within 5 minutes, then
it stops searching. The connection icon stops flashing and the temperature display
shows "-._°C" and "--%" on the display.
In most cases, the connection cannot be established due to specific factors such
as reinforced walls or too great a distance between the sensor and the main unit.
In this case, position the sensor and the main unit closer to each other. To restart
scanning, press and hold the "Channel button" on the front of the main unit for
3 seconds until the connection symbol in the display starts flashing.
6. Display
Time display:
20
The time can be displayed in a 12-hour or 24-
hour format. The current time is received via
the outdoor sensor!
English