Alarm Setting - BEARWARE 302547 Bedienungsanleitung

8.2 Alarm setting

The weather station can store up to 2 alarm settings, which can be turned on and
off separately.
Setting the alarm
Press and hold the "ALARM/SET" button for about 3 seconds to access the alarm
settings. The alarm time is now displayed instead of the time. You can make the
desired settings using the "UP" and "DOWN" buttons. Then press the "ALARM/
SET" button again to save the alarm setting. You can configure these settings using
Alarm 1 (A1) and Alarm 2 (A2).
Enabling the alarm
Press the "DOWN" button in time mode. An alarm icon is subsequently displayed
next to the time. This means that the alarm is enabled. To disable alarm 1 and to
enable alarm 2, press the "DOWN" button again. Pressing the "DOWN" button
again enables alarm 1 and alarm 2. Both alarm symbols are shown in the display.
Both are disabled by pressing the "DOWN" button again. The symbols then
disappear from the display.
Switching off the alarm
When the alarm is activated at the configured time, the backlight also turns on
automatically. The alarm is active for 2 minutes before it turns off automatically.
Press the "SNOOZE/LIGHT" button to cancel the alarm. If a snooze symbol is
shown on the display, this means that the snooze function is activated and the
alarm will go off again in 5 minutes.
Press any button to switch off the alarm.
78
English