BEARWARE 303530 Kurzanleitung Seite 23

Outdoor temperature display:
Channel display
1, 2, 3: Outdoor sensor channel
: Automatic channel change after 4 seconds
8. Basic settings
Note: Firmly touching the top of the housing will switch on the backlight. After
the "SNOOZE/SLEEP" button is touched, the backlight switches off again after 5
seconds. Please note that the base station does not respond to 2 buttons at the
same time. Therefore, it is advisable to always press just one button.
Press the "Mode" button briefly to display the time and date.To change the basic
settings, press and hold the "SET" button until the time zone starts to flash. With
the "UP" and "DOWN" buttons, you can change the values accordingly. Confirm
the settings by briefly pressing the "SET" button and you can then access the next
setting option.
English
The outdoor temperature is measured by the
outdoor sensor and shown to an accuracy of
one tenth of a degree. The configured tempera-
ture unit is displayed to the right of the reading.
The temperature unit can be changed between
°C and °F. To do this, press the "SET" button on
the weather station.
This display shows the current air humidity
experienced by the weather station.
The weather station receives the signal of the outdoor
sensor automatically after all settings have been
configured. You can switch between the different
channels using the "Channel" button. The channels
of the outdoor sensor can be selected on the sensor
directly using a toggle switch.
23