Integra Omni-Tract Gebrauchsanweisung Seite 5

3
Position the support arm over the patient so
that the distal end of the arm is approximately
at the midline and is three to five centimeters
above the patient and ten centimeters above
the top of the incision. Lock the support arm
position by pushing down on the securing
handle (1).
4
Before attaching frame arms make sure the large handle at the end of the
support arm is in the unlocked position (1).
Anterolateral Set-up
*10 centimeters
5
Attach frame arms to the support arm by inserting the end of the frame into
the socket of the ball joint. There are flattened sections of the frame arm that
will correspond to the ball joint socket (inset). The frame arms may need to
be rotated within the socket in order to line up with the flattened sections
of the ball socket to engage properly. Remove frame arms by grasping the
round flange on the arm (1) and pulling arm straight back.
5
Posterolateral Set-up
*10 centimeters
EN – ENGLISH