Filling The Pressure Sprayer Tank; Building Up The Operating Pressure; Spraying - FLORABEST Z30597 Bedienungsanleitung


Filling the pressure
Q 
sprayer tank (Fig. E)
note: Before using the product, check to
see that it is in good condition and free of
defects.
j 
P ress the pump handle
and turn it anticlockwise.
note: Before you open the tank, pull
the safety valve
any residual pressure still present in the
container
j 
D raw the pump
.
5
j 
N ow fill the tank. Ensure that the use of
the pesticide, liquid fertiliser or cleaning
agent is permitted in your country and
that it is compatible with your pressure
sprayer.
note: Fill the tank with only the
amount of liquid that you actually need
for that particular spraying session (not
more than 5 l).
j 
P lace the pump
tainer and turn the pump handle
5
clockwise as far as it will go.
Building up the operating
Q 
pressure (Fig. F)
j 
F old out the two footplates
j 
B efore you start pumping, place your
feet on the footplates
the pressure sprayer is held in a stable
position during the pumping process.
j 
M ove the pump handle
until the pressure sprayer has been
pumped up to a pressure not exceeding
the maximum permissible operating
pressure of 2.5 bar. To ensure this value
®
56222_flo_Drucksprüher_Content_LB4.indd 11
downwards
1
upwards to release
3
.
5
out of the container
2
back into the con-
2
.
7
to ensure that
7
up and down
1
is not exceeded, monitor the pressure
gauge during the pumping process.
4
note: If the pressure of the air in the
container exceeds 2.5 bar, the pres-
5
sure is automatically released through
the safety valve
j 
P ress the pump handle
into the recesses.
j 
T urn the pump handle
far as it will go. This secures the handle.
j 
N ow take the spray tube
holder.
j 
F old in the two footplates
Spraying (Fig. G)
Q 
j 
H ang the pressure sprayer over your
shoulder by the carrying strap
note: Ensure that the pressure sprayer
is always kept upright. Only when held
in this orientation will the sprayer work
properly.
j 
H old the spray tube firmly by the han-
dle and direct the adjustable spray
1 17
nozzle e.g. at a plant.
11
j 
S et the adjustable spray nozzle
provide the desired spray cone. To create
a broad spray cone, turn the front part
of the adjustable spray nozzle
wise. To create a concentrated jet, turn
the front part of the adjustable spray
nozzle anticlockwise.
11
j 
P ress the trigger
process.
j 
R elease the trigger
spraying process.
note: When the pressure in the con-
tainer is no longer sufficient to spray,
5
pump the container
pressure again up to but not exceeding
the maximum permissible operating
Bringing into use
.
3
downwards
1
clockwise as
1
out of the
12
.
7
.
6
to
11
clock-
11
to start the spraying
19
to stop the
19
to increase the
5
GB 11
02.12.10 16:20