Klarstein FULL HOUSE DOWN AIR Handbuch Seite 74

EN
74
Problem Possible causes
The induction This is caused by the
hob technology
makes a low of induction cooking.
humming
noise when
used on
a high heat
setting.
Fan noise A cooling fan built into your
coming from induction hob has come on to
the induction prevent the electronics from
hob. overheating. It may continue to
run even after you ve turned the
induction hob off.
Pans do not 1 The induction hob cannot
become hot detect the pan because it
and appears is not suitable for induction
in the display. cooking.
2 The induction hob cannot
detect the pan because it
is too small for the cooking
zone or not properly centred
on it.
The induction Technical fault.
hob or a
cooking zone
has turned
itself off
unexpectedly,
a tone
sounds and an
error
code is
displayed
(typically
alternating
with one or two
digits in
the cooking
timer
display).
What to do
This is normal, but the noise
should quieten down or
disappear completely when
you decrease the heat setting.
This is normal and needs no
action. Do not switch the power
to the induction hob off at the
wall while the fan is running.
Use cookware suitable for
induction cooking. See section
„Choosing the right cookware .
Centre the pan and make sure
that its base matches the size of
the cooking zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.