Router Cage; Changing The Batteries; Cleaning, Care And Storage - Parkside PFBS 160 B2 Originalbetriebsanleitung

Router cage

With this attachment, the appliance is particularly
suitable for cutting special forms (holes for plugs,
etc .) .
♦ Insert the milling bit
section "Changing/inserting the tool/collet
chuck" .
♦ Ensure that the shaft of the bit protrudes out of
the collet chuck by about 16 mm .
♦ Screw the union nut
appliance and store it carefully .
♦ Screw the router cage
♦ To set the correct working height, undo the
locking screw and adjust the foot of the
router cage to the desired size .
♦ Afterwards, retighten the locking screw
PFBS 160 B2
as described in the
anticlockwise off the
onto the appliance .
.
ca. 16 mm

Changing the batteries

♦ Make sure that the LED light is turned off .
Remove the three screws from the rear of the
grip ring with LED
♦ Replace the used batteries in the appliance
with new batteries of the same type (button
cell LR41) . Note polarity when installing new
batteries .
♦ Close the battery compartment again by
replacing the three screws .

Cleaning, care and storage

WARNING! RISK OF INJURY!
■
Switch the appliance off and remove the
power plug before starting any work on
the appliance.
The appliance is maintenance-free .
■ Remove all dirt from the appliance . Use a dry
cloth to do this .
WARNING!
■ If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or an authorised representative in order to
avoid safety hazards .
■ Store the appliance and all the individual
pieces in the provided plastic case to ensure
you do not lose any part .
NOTE
► Replacement parts not listed (such as the
rechargeable battery, battery charger) can
be ordered via our service hotline .
WARNING!
■ Always ensure that the power plug or the
mains cable is replaced only by the manu­
facturer of the appliance or its customer
service. This will ensure that the safety of the
appliance is maintained .
.
GB │ MT │ 67 ■