Setting The Impact Force; Use; Switching On And Off; Stapling/Nailing - Parkside PET 25 C3 Originalbetriebsanleitung

Setting the impact force

NOTE
► Select the lowest impact force sufficient for
stapling. Take into account the length of the
staples or nails you are using as well as hard-
ness of the material you are working with.
Impact force control
Increasing the impact force
♦ Turn the impact force control
Reducing the impact force
♦ Turn the impact force control

Use

Switching on and off
♦ Set the ON/OFF switch
switch the appliance on.
♦ Set the ON/OFF switch
switch the appliance off.
│ GB │ IE
■ 6
anticlockwise.
clockwise.
to the position "I" to
to the position "0" to

Stapling/nailing

♦ Switch the appliance on by moving the ON/
OFF switch to the position "I".
♦ Press the face plate
the location on the material that you want to
staple/nail.
♦ Press the trigger
NOTE
► The integrated safety switch on the face plate
prevents accidental triggering.

Working with the rip fence

If you want to tack with nails or staples at a
constant distance to an edge, proceed as follows:
♦ Pull out the rip fence
arrow.
♦ Move the rip fence
is at the required distance from the edge of the
object that you want to work on.
♦ Place the rip fence
object that you want to work on.
♦ Proceed as described in the section Stapling/
nailing.
of the appliance onto
.
in the direction of the
along the scale
onto the edge of the
PET 25 C3
until it