Klarstein Illuminosa Bedienungsanleitung Seite 41

Automatic electrical ignition
(only certain versions, see figure 9, ref. Ac)
1. The command of lighting is integrated in the control knob. Press and turn
anclockwise the knob corresponding to the burner you wish to use from "Off"
position, until it reaches the "Maximum" position (see figure 10) corresponding to
the big flame. Automatically the ignition spark shoots. Keep the knob pressed until
flame ignition. Matches can be used to light the burners in a blackout.
2. After ignition, turn the handle from "Maximum" position (corresponding to the big
flame) to "Minimum" position (corresponding to the little flame) and check the
stability of the flame. To turn the burner off, turn clockwise the handle up to "Off"
position.
Lighting of burners equipped with safety thermocouples
(only certain versions, see figure 9, ref. Tc)
1. In case burners are fitted with Flame Safety Device (FSD = Thermocouple, figure 9,
Tc), repeat operations described previously.
2. Once the flame is alight, keep the knob pressed for about 10 seconds to allow the
Flame Safety Device (FSD = Thermocouple) to warm up. If, at the end of this time,
the burner fails to alight, it means that Flame Safety Device (FSD = Thermocouple) is
not sufficiency heated. Repeat the operation.
Optimum use of the burners
To get the maximum yield with the minimum consumption of gas it is handy to keep the
following points in mind:
• Once the burner has been alighted, adjust the flame according to your needs, from
"Maximum" position (big flame) to "Minimum" position (little flame).
• Use proper pan size (with flat bottom only) for each burner (see the table below
and figure 1 1).
Off position
Maximum position (big flame)
Minimum position (little flame)
Ignite
Figure 10
EN
41