Gas Connection (Installer) - Klarstein Illuminosa Bedienungsanleitung

GAS CONNECTION (INSTALLER)

Note: The installation, the adjustments, conversions and maintenance of the
appliance must only be carried out by a qualifi ed technician or installer. Do not
connect the appliance to the gas supply yourself!
Important notes on gas connection
• Before to connect the appliance to the gas network, check that the adjustment
sticker data plate, put on the bottom of the appliance, correspond to the available
one in the gas network. The adjustment sticker data plate, gives all the appliance's
setting conditions as: gas type and gas operating pressures.
• Once installed, check there are no leaks using a soapy solution only. Never use a
fl ame! It is forbidden!
When gas is distributed through ducts the appliance must be connected to the gas
mains with:
• A fl exible stainless steel, seamless pipe in accordance with the National Rules
in force, with a maximum 2 metres extension and seals in accordance with the
National Rules in force. Make sure that the pipe, once the appliance is installed,
does not come into contact with the mobile parts of the unit in which the hob is built-
in (like drawers for instance), get squashed or is too bent.
• A rigid steel pipe in accordance with the National Rules in force, whose joints must
be made using, threaded fi ttings in accordance with the Standard ISO 7/1. The use
of hemp with suitable adhesives or Tefl on tape as a sealant is not allowed.
• A copper pipe in accordance with the National Rules in force, whose joints must be
made using sealed fi ttings in accordance with the National Rules in force.
When gas is supplied directly from a gas cylinder, the appliance, supplied by a
pressure regulator must be connected:
• With fl exible stainless steel, seamless pipes in accordance with the National Rules
in force with a maximum 2 metres extension and seals in accordance with National
Rules in force. Make sure that the pipe does not come into contact with the mobile
parts of the unit in which the hob is built-in (like drawers for instance), get squashed
or is too bent. We recommend attaching the special adapter to the fl exible pipe,
easily found on the market, to facilitate connection to the pressure regulator's hose
fi tting on the cylinder.
Anyway, the pipe connecting the appliance with the gas mains should lie with smooth
bends ,and the rubber gasket preventing leakage added by user between the
appliance's gas inlet fi tting and the pipe connection must comply with the Standard
EN 549 (available in specialized shops).
CAUTION
Risk of material damage and personal injury! Carry out the connection
avoiding all kinds of stress to the appliance.
EN
37