Adjusting The Appliance (Installer) - Klarstein Illuminosa Bedienungsanleitung

EN
38

ADJUSTING THE APPLIANCE (INSTALLER)

• Check the adjustment of the appliance, before to make any adjusting operation,
having a look on proper adjustment sticker data plate, put on the bottom of the
appliance.
• Before any adjustment is attempted, which may be necessary when installing for the
first time or when converting gas type, take the plug out of the mains socket.
• When the adjustment or preadjustment has been made, a technician must do any
re-sealing, if any.
• To adjust "reduce rate", using proper screw driver, from Natural gas to Butane/
Propane ones, light burners one by one and put handle in minimum position (little
flame). Remove the handle and screw clockwise completely the by-pass screw.
Put back in position the handle and check stability flame, turning the handle from
"Maximum" position (big flame) to "Minimum" position (little flame) and vice-versa.
• To adjust "reduce rate", using proper screw driver, from Butane/Propane gases
to Natural one, light burners one by one and put handle in minimum position (little
flame). Remove the handle and unscrew anclockwise in the way to get proper
flame. Put back in position the handle and check stability flame, turning the handle
from "Maximum" position (big flame) to "Minimum" position (little flame) and
vice-versa.
• "Primary air adjustment" on hob gas burners is unnecessary.
Adjusting gas taps
The adjustment of the reduced rate position is as follows:
• Light the burner and turn the knob to reduced rate position (little flame).
• Remove the knob which is simply inserted onto tap stem.
• Insert a small screwdriver into the top shaft and turn the throttling screw left or right
until flame of the burner is conveniently regulated to the low position.
• In the case of taps with safety thermocouples, the adjustment screw is on the side of
the stem.
• Make sure that when turning quickly from "Maximum" position to "Minimum"
position, the burner does not extinguish.
Note: If the tap, after long use of the hob, presents some friction to rotation, do not
insist to use it. Contact customer service to have the tap substituted with the proper
one.