Klarstein Illuminosa Bedienungsanleitung Seite 33

Location and aeration
Gas appliances must always discharge the products of combustion through extractors
connected to fl ues or directly to the outside (see fi gure 2). If it is impossible to use an
extractor, a fan installed on the window or on a wall facing the outside is allowed and
should be switched on each time the appliance is used (see fi gure 3), provided the rules
and regulations in force relating to ventilation.
(*) Air inlet: minimum section 100 cm
Figure 1
Note: When a gas appliance is being used it produces heat and humidity in the
room where it is installed. For this reason the room must be well ventilated, keeping
the natural ventilation openings free (see fi gure 1) and switching on the mechanical
aeration system (suction hood or electric fan – see fi gures 2 and 3).
If the cooker is used for a long time additional aeration may be necessary, for
instance, opening a window or a more effective aeration by increasing the power of
the mechanical system if there is one.
Unpacking the appliance
Once the outer wrapping and the inner wrappings of the various parts have been
removed, check and make sure that the appliance is in perfect condition. If you have
any doubts, do not use the appliance and contact customer service.
Some parts are mounted on the appliance and protected by a plastic fi lm. This protective
fi lm must be removed before ever the appliance is used. We recommend slitting the
plastic fi lm along the edges with a sharp knife or pin.
CAUTION
Risk of suffocation and injury for children! The packaging materials used
(cardboard, bags, polystyrene foam, nails ...) should not be left
anywhere within easy reach of children as they are a potential hazard
source.
2
Figure 2 Figure 3
EN
33