SWM SM 125 R 2020 Kurzanleitung Seite 48

SM125
DIRECTION INDICATOR LIGHTS
The light flashes when activating the left or right hand turning indicator
using the control lever on the left-hand switch.
HIGH-BEAM LIGHT " "
The light comes on when activating the high-beam light using the control on
the left-hand switch.
NEUTRAL WARNING LIGHT" "
The light comes on when the gear shift lever is in neutral position (no gear
engaged).
ENGINE FAILURE WARNING LIGHT"
When the ignition key is turned, the engine control unit runs a self-test, the
light comes on for a few seconds and then goes off if no fault is found
If the light comes on while the engine is running, it means that there is an
engine or injection system failure.
- Stop and turn off the engine.
- Wait a few minutes and restart the engine; if the light comes on again,
contact your nearest SWM dealer to have the self-test system checked.
EXCESSIVE COOLANT TEMPERATURE INDICATOR.
The indicator lighting up warns that the engine overheated reaching an
alarm temperature.
14 / EN
" "
"
"
"
- Stop and turn off the engine;
- Wait for the engine to cool down and then restart the engine.
If the problem occurs again, it is necessary to refer to the nearest SWM's
dealer for a check.
MULTIFUNCTION DISPLAY
1) Speedometer
Indicates motorcycle speed.
2) Speed scale indication:
Km/h = kilometres /hour
Mph = miles/hour
3) Display parameters
The following parameters that will be displayed in the field (4) can be
individually set in this field.
ODO = Odometer (read-only value)
TRIP = Partial odometer (see TRIP settings)
5) Unit of measurement
Mile = indicates that the valued indicated in the
ODO and TRIP functions is in miles
Km = indicates that the valued indicated in the
ODO and TRIP functions is in kilometres