Safety Instructions; Safety Precautions - Ingersoll-Rand Nirvana Serie Bedienungsanleitung

12207.13.10

5.1 SAFETY INSTRUCTIONS

Safety instructions in the operators manual are
bold−faced for emphasis. The signal words DANGER,
WARNING and CAUTION are used to indicate hazard
seriousness levels as follows.
Ensure that the operator reads and understands the
decals and consults the manuals before maintenance
or operation.
DANGER
Indicates the presence of a hazard which WILL cause
serious injury, death or property damage, if ignored.
WARNING
Indicates the presence of a hazard which CAN cause
serious injury, death or property damage, if ignored.

5.2 SAFETY PRECAUTIONS

General Information
Compressed air and electricity can be dangerous.
Before undertaking any work on the compressor,
ensure that the electrical supply has been isolated,
locked off, tagged and the compressor has been
relieved of all pressure.
Make sure that all protective covers are in place and
that the canopy/doors are closed during operation.
Installation of this compressor must be in accordance
with recognized electrical codes and any local Health
and Safety Codes.
Use only safety solvent for cleaning the compressor
and auxiliary equipment.
Compressed air
Ensure that the machine is operating at the rated
pressure and that the rated pressure is known to all
relevant personnel.
All air pressure equipment installed in or connected to
the machine must have safe working pressure ratings
of at least the machine rated pressure.
6
5.0 SAFETY
IRN37−160K−CC & IRN50−200H−CC & IRN75−160K−2S & IRN100−200H−2S & IRN250−300H−2S
Ensure that the Operation and Maintenance manual,
and the manual holder, are not permanently removed
from the machine.
Ensure that maintenance personnel are adequately
trained, competent and have read the Maintenance
Manuals.
CAUTION
Indicates the presence of a hazard which WILL or can
cause injury or property damage, if ignored.
NOTICE
Indicates important set−up, operating or maintenance
information.
If more than one compressor is connected to one
common downstream plant, effective check valves and
isolation valves must be fitted and controlled by work
procedures, so that one machine cannot accidentally
be pressurized / over pressurized by another.
If a safety valve is installed between the isolation valve
and the compressor, it must have sufficient capacity to
relieve the full capacity of the compressor(s).
The discharged air contains a very small percentage of
compressor lubricating oil and care should be taken to
ensure that downstream equipment is compatible.
If the discharged air is to be ultimately released into a
confined space, adequate ventilation must be provided.
The use of plastic bowls on line filters without metal
guards can be hazardous. Their safety can be affected
by either synthetic lubricants, or the additives used in
mineral oils. Metal bowls should be used on a
pressurized system.
When using compressed air always use appropriate
personal protective equipment.
http://air.irco.com