Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
R911338219 | PSI 6xCx.156
10.1.2 Updates from Firmware Version -AC-103
• Flow protection inputs for gun 1 and gun 2
• Notice: With this firmware version, a 24V signal must be applied to the
corresponding input "Flow protection gun 1" or "Flow protection gun 2"
during a welding sequence that is started via Start 1 or 2.
• Trouble shooting „Watchdog error after new spot selection"
• Correction of the transformer parameter for the power class PSI6500L1
• Trouble shooting „sporadic driver fault"
• Update XQR control version V414 → V416.02
Calculation of time prolongation ALU adapted.
o
Calculation of the factors for monitoring of gun movement
o
adapted.
Object extension for the filter criteria training mode (PSF,
o
UIP...) and for the referencing phase monitoring gun
resistance adjustment.
10.1.3 Updates from Firmware-Version -AD-104
• Outputs „"Prelift open" - impulse / welding gun 1" and „"Prelift open" -
impulse / welding gun 1 2" intergated in lamp test.
10.1.4 Updates from Firmware-Version –AE-105
• Update XQR control version V416.02 → V417.01
Function "weldtime reduction" implemented.
o
Function "STC weld time prolongation" revised.
o
Function "Tipdress monitoring QLogic".
o
Endtime for spatter detection implemented.
o
Display of contact waittime in the GUI.
o
Contact Error "No sheet contact" is now grouped in two
o
different errors "sheet-sheet contact error" or "electrode-
sheet contact error".
Error "UIP too high" in case of spatter (timeslice) updated.
o
Upgrade glue contacting, if contact testtime has been
o
shifted.
Troubleshooting sequence abort measuring circuit test
o
force (display programmed and actual values).
• Trouble shooting: weld warning can also be reset again after an
automatically rest error.
• Program selection optional with variant selection.
Bosch Rexroth AG
57/59
Annex
Werbung
Kapitel
Inhaltsverzeichnis
