Replacing The Fan; Removing The Cover; Fitting The Cover - Kaco blueplanet 87.0 TL3 Betriebsanleitung

1 | General information
7.3

Replacing the fan

Removing the cover

↻ A check has been performed to ensure there is no AC/DC voltage
present.
1. Remove the fastening screws on the cover from both sides [ _T20]
2. Lift up the cover from both sides and press it out of the mounting clips.
3. Set the cover to one side.
ð Proceed with the cleaning or removal of the fans.
Dismounting the fan
↻ It has been ensured that there is no AC/DC voltage present.
↻ DANGER! Risk of injury from starting fans: If the device is not com-
pletely disconnected from the voltage source, the fan may start up
unexpectedly and sever or injure limbs. This may also cause damage
to the fan and impair the functionality of the device.
↻ Cover hood for fans removed.
1. Wait until the 3 fans have stopped rotating.
2. Rotate the defective fan through approx. 10° in the clockwise direction and re-
move it carefully using the collar.
3. Release the interlock and remove the connector plug from the inside of the
housing.
4. Remove the fan.
5. If necessary, clean the heat sink from above.
ð Install the replacement fan.

Fitting the cover

↻ The fan has been correctly installed and all impurities in the area of the
cover have been removed.
1. Lift up the cover from both sides, place it on the mounting clips and carefully
press it in.
2. Insert the fastening screws into the cover on both sides and tighten them [
_T20 / 2.2 Nm].
ð You may now start up the device Commissioning.
Page 24
Operating Instruction I
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 105 TL3 KACO blueplanet 110 TL3
KACO blueplanet 125 TL3 KACO blueplanet 137 TL3 KACO blueplanet 150 TL3 KACO blueplanet 155 TL3
4
3
2
Fig. 27: Removing the cover
1 Cover
2 Fastening screw
3 Mounting clips
4 Fans
1
2
Fig. 28: Removing the fans
1 Fans
2 Connector
2
Fig. 29: Fitting the cover
2 Fastening screw
KACO blueplanet 165 TL3
1