Installing And Securing The Device - Kaco blueplanet 87.0 TL3 Betriebsanleitung

1 | General information
↻ Cardboard packaging with mount and mounting kit removed from the packaging and opened.
1. Mark the mounting position on the wall surface according to the position of the mount by drawing a line.
2. Mark the positions of the drill holes using the slot in the mount.
. NOTE: The minimum clearances between two devices, or the device and the ceiling or floor have
already been taken into account in the diagram.
3. Fix the mount to the wall using suitable mounting fixtures from the mounting kit.
. NOTE: Make sure that the mount is oriented correctly.
ð Proceed with the installation of the device.
5.4

Installing and securing the device

CAUTION
Risk of injury from improper lifting and transport.
If the device is lifted improperly, it can tilt and result in a fall.
1. Always lift the device vertically using the openings provided.
2. Use a climbing aid for the chosen installation height.
3. Wear protective gloves and safety shoes when lifting and lowering the device.
NOTE
Power reduction due to heat accumulation!
If the recommended minimum clearances are not observed, the device may go into power regulation mode
due to insufficient ventilation and the resulting heat build-up.
1. Observe minimum clearances and provide for sufficient heat dissipation.
2. All objects on the device housing must be removed during operation.
3. Ensure that no foreign bodies prevent heat dissipation following device installation.
Lifting and installing the device
↻ The mount has been installed.
1. Lift the device using the side recesses. Observe the device's centre of gravity!
. NOTE: Do not lift the device by the lid or cover!
2. Fit the device onto the upper mount by means of the mounting bracket. Fit the device onto the lower mounting
bracket in full so that the device sits flush with its rear side on the mount ( [Fig. 11: Wall mounting [}[13]).
3. Insert the screw provided into the lug of the mount and secure the device to prevent it from being lifted off [ T30 /
2 Nm] [Fig. 10: Minimum clearances for wall mounting [}[13].
. NOTE: Alternatively: At this point, the screw described above can be replaced by a special screw as
anti-theft protection.
ð Device is installed. Proceed with the electrical installation.
Page 14
Operating Instruction I
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 105 TL3 KACO blueplanet 110 TL3
KACO blueplanet 125 TL3 KACO blueplanet 137 TL3 KACO blueplanet 150 TL3 KACO blueplanet 155 TL3
KACO blueplanet 165 TL3