Installation; General Information | 1; Opening The Device - Kaco blueplanet 87.0 TL3 Betriebsanleitung

Operating Instruction I
6

Installation

6.1 General information
DANGER
Lethal voltages are still present in the connections and cables of the device even after the device
has been switched off and disconnected!
Severe injuries or death may occur if the cables and/or terminals/busbars in the device are touched.
1. The device must be mounted in a fixed position before being connected electrically.
2. Comply with all safety regulations and current technical connection specifications of the responsible power
supply company.
3. The device is only permitted to be opened or serviced by a qualified electrician.
4. Switch off the grid voltage by turning off the external circuit breakers.
5. Check that all AC and DC cables are completely free of current using a clip-on ammeter.
6. Do not touch the cables and/or terminals/busbars when switching the device on and off.
7. Keep the device closed when in operation.
↻ NOTE: S version: The device is shut down externally at the combiner
box.
1. Switch the DC isolator switch from 1 (ON) to 0 (OFF).
2. Press in the safety catch (1) from behind.
3. Attach the hanging lock (2) to the safety catch.
. DANGER! A measurement in a live state may be required for tests.
Only appropriately qualified electricians authorised by the mains
supply network operator are permitted to open and maintain the
device.
. DANGER! Observe all safety regulations against harmless contact
with live materials.
6.2

Opening the device

↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
1. Undo the 6 screws and carefully remove the housing cover [ T_25]
2. Take care not to damage or soil the seals and fibre optics when setting down the
housing cover.
ð Proceed with the installation of the device.
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 105 TL3 KACO blueplanet 110 TL3
KACO blueplanet 125 TL3 KACO blueplanet 137 TL3 KACO blueplanet 150 TL3 KACO blueplanet 155 TL3 KACO
blueplanet 165 TL3

General information | 1

Fig. 12: Lock DC circuit breakers to pre-
vent reconnection.
Fig. 13: Remove housing cover
1
2
1
2
Page 15