Cleaning; Cleaning The Housing; Cleaning The Heat Sink - Kaco blueplanet 87.0 TL3 Betriebsanleitung

Operating Instruction I
7.2

Cleaning

7.2.1

Cleaning the housing

WARNING! Do not use compressed air or high-pressure cleaners!
1. Use a vacuum cleaner or a soft brush to remove dust from the fan cover and from the top of the device on
a regular basis.
2. Remove dust from the ventilation inlets if necessary.
7.2.2

Cleaning the heat sink

WARNING
Risk of burns from hot surface.
Heat sinks become very hot when in operation.
1. Never touch the heat sinks after commissioning the device.
2. Allow the heat sinks at least 10 minutes to cool down before cleaning.
NOTE
Refer to our service and guarantee conditions on our homepage.
ü The cleaning intervals must be adapted to match the ambient conditions of the installation location.
1. In sandy environments, we recommend cleaning the heat sinks and fans every quarter.
↻ Cleaning the heat sink requires the fan to be removed.
↻ Switch off the device and secure it against restart.
↻ Keep a suitable brush ready for cleaning.
1. Remove the hood and fan Replacing the fan [See section 7.3}[24].
2. Clean the free space between the cover and the heat sink using suitable
brushes.
3. Clean the heat sink with a suitable brush.
. NOTE: Do not use any aggressive cleaning agents and ensure that no
other components come into contact with fluids.
ð Cleaning completed – if necessary, remount the fans.
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 105 TL3 KACO blueplanet 110 TL3
KACO blueplanet 125 TL3 KACO blueplanet 137 TL3 KACO blueplanet 150 TL3 KACO blueplanet 155 TL3 KACO
blueplanet 165 TL3
General information | 1
2
Fig. 25: Cleaning the cooling fins from
above
Fig. 26: Cleaning the cooling fins from
below
1 Heat sinks / space between
heat sinks
2 Brush (max. wire diameter
2mm)
3x
2 mm
1
4x
2
1
Page 23