Cleaning The Heat Sink; Replacing The Fan - Kaco blueplanet 15.0 TL3 Bedienungsanleitung

2 Remove dust from the ventilation inlets if necessary.

8.2.2 Cleaning the heat sink

WARNING
Risk of burns from hot surface.
Heat sinks become very hot when in operation.
› Never touch the heat sinks after commissioning the device.
› Allow the heat sinks at least 10 minutes to cool down before cleaning.
NOTE
Refer to our service and guarantee conditions on our homepage.
ü The cleaning intervals must be adapted to match the ambient conditions of the installation location.
› In sandy environments, we recommend cleaning the heat sinks and fans every quarter.
↻ If the heat sink is heavily soiled, we recommend that you dismount the fan tem-
porarily.
↻ Switch off the device and secure it against restart.
1 Clean the space between the heat sink with a suitable brush.
NOTE: Do not use any aggressive cleaning agents and ensure that no other
components come into contact with fluids.
» Cleaning completed – if necessary, remount the fans.
8.3

Replacing the fan

The device is equipped with an axial fan. This is located in the upper section of the side panel of the housing. Replace the
fan in the following circumstances:
ž Heavy soiling
ž A fault
Page 24
5mm
2
1
Fig. 20: Clean the cooling fins
1 Heat sink / space between
heat sink
2 Brush (max. wire diameter 3
mm)
6
KACO blueplanet 15.0 TL3 KACO blueplanet 20.0 TL3
4
5