Fastening The Mount; Opening The Device; Making The Electrical Connection; Connecting The Device To The Power Grid - Kaco blueplanet 87.0 TL3 Kurzanleitung

Code (s)
External hexagon
W
Internal hexagon
A
Torx
T
Slot
S
Tab. 1: Key and description of tool codes
3.3

Fastening the mount

WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seri-
ously injured.
› Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only to be used for masonry and concrete.
› Only install the device in an upright position.
4 Installation
4.1

Opening the device

↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
1 Undo the 6 screws (2) and carefully remove the housing cover (1) [
2 Take care not to damage or soil the seals and fibre optics when setting down
the housing cover.
» Proceed with the installation of the device.
4.2

Making the electrical connection

NOTE
Select conductor cross-section, safety type and safety value in accordance with the following basic condi-
tions:
Country-specific installation standards; power rating of the device; cable length; type of cable installation;
local temperature
Detailed information on tightening torques: See comprehensive operating instructions under
ergy.com/de/downloads
4.3

Connecting the device to the power grid

4.3.1 Prepare the grid connection
Page 6
Shape of the
connector
Tightening torque
Spanner size or number
Outer contour
Fig. 1: Form pattern
T_25]
Fig. 2: Remove housing cover
Photovoltaic feed-in inverter - KACO blueplanet 87.0 - 165TL3
Nm
1
2
http://www.kaco-newen-