Cleaning And Maintenance; Danger To Life; Replacing The Fuse - EuroLite DPX-405 DMX Bedienungsanleitung

3) Set you desired chase pattern via the Up and Down buttons.
4) Set you desired chase speed: At this point you may change the program chase speed. While in chase
mode, tap on the MENU button until the "SP" followed by two numbers is displayed in the LCD. Then use
the UP and DOWN buttons to adjust the chase speed. A value of 99 will give you the fastest chase
speed (about 1/10th of a second). A value of 01 will give you the slowest chase speed (one step every
30 sec.).
5) You may now change the light intensity: Use the MENU button to select "d" in the LCD. Use the UP and
DOWN arrow keys to change the light output intensity. 00 will give the lowest output and 99 will give you
full intensity.
6.2 DMX Mode
Use this operating mode only if you plan to use your pack as a DMX dimmer. This function will allow you to
turn on and control the intensity of non-DMX with the use of a DMX controller. On, off, and dimming functions
can be performed through this pack. You may also set your dimmer pack to function as a 1, 2, or 4 channel
DMX dimmer pack, which means you can combine the output functions.
DMX Operation:
1) Plug in a DMX controller to your dimmer pack via the 3-pin XLR cables.
2) Connect your spotlights to the terminal outputs.
3) Decide if you are going to use your dimmer pack as 1, 2, or 4 channels. This function allows you to:
A. Control the output to all four output with one DMX channel.
B. Group outlet channels one and two and group outlets channels three and four. The first group will be
controlled by one DMX channel and the second group will be controlled by another DMX channel.
This gives the pack a DMX value of two.
4) The default setting is a four channel DMX switcher, each channel is controlled by one DMX channel.
5) To change the channel function mode be sure you are in DMX mode. Use the MENU button to select
"CH" followed by two digits. Then use the UP and DOWN arrow buttons to change the setting from 01,
02, or 04. Your dimmer pack is initially set as a four channel DMX switcher.
6) The dimmer pack is initially set to be activated by DMX address one. To change this setting be sure you
are in DMX mode. Use the MENU button to select the address settings, this will be indicated by an "A" in
the first character of the LCD followed by three numbers. Use the UP and DOWN arrow buttons to select
your desired DMX address. Remember the DMX address tells your DMX controller what channel to
activate the pack's functions.
7) Once you have set the pack's DMX address be sure your controller's address matches that of the
pack's.
8) Your pack will now operate as DMX dimmer, you may control the light output intensity through your DMX
controller. 0 will give no output and 255 will give you full output.

7. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

7.1 Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.

DANGER TO LIFE!

Disconnect from mains before starting maintenance operation!
15/28 70064110_V_1_0.DOC