CH 14
G4
CH 15
B4
CH 16
CH 17
CH 18
CH 19
CH 20
CH 21
CH 22
CH 23
CH 24
CH 25
CH 26
CH 27
MASTER/SLAVE MODE
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED Flood Light PIX-24 RGB you can find an XLR-jack and an XLR-plug, which can
be used for connecting several devices.
This device then works as master-device and controls the slave-devices, which are to be connected to the
master-device via a stereo shielded cable. Connect the DMX OUT jack with the DMX IN plug of the next
device.
Press the MODE button to select the SLAVE mode. The devices set in this manner can now be controlled by
the master unit.
Please press the ENTER button to confirm and to exit the SLAVE Mode.
SOUND CONTROL MODE
Press the MODE button and choose Sound Controlled Mode (SOUND).
Press the ENTER button to select the desired sensitivity and frequency of the loops, respectively.
The desired sensitivity (SENS 00-31) and frequency of the loops (Frequency = FQN 01-99) can be selected
via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to exit the SOUND Mode.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
R5
G5
B5
R6
G6
B6
R7
G7
B7
R8
G8
B8
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
21/36
00056994.DOC, Version 1.1