Delivery And Storage; Storage And Handling - EBARA 6 Serie Bedienungs- Und Installationshandbuch

These operating instructions contain relevant information
and precautionary notes. Please read the manual
carefully before assembling, electrical connection and
commissioning.
This pump has been developed according to the
most advanced and recent technology, as well as in
compliance with the regulations in force. Moreover, the
pump is subject to a permanent quality control.
These operating instructions are intended to help you
better understand the pump operation and to show you
its possible applications.
The manual contains important information necessary
operating instructions is of vital importance to ensure the
reliability and a long service life of the pump, as well as to
avoid any accident risk due to improper use.
This pump must not be operated beyond the limit values
concerning the nature, the density, the temperature, and
speed, the pressure and the power of the motor shall be
observed. Any other instruction contained in this manual
or in the documentation enclosed to the agreement shall
be observed as well.
The rating plate bears the type series, the main
operation data, and the serial number. Please, quote this
information in all request of intervention or assistance,
and when ordering spare parts.
This manual contains essential instructions that must be
observed during installation, operation and maintenance.
Therefore, this operating handbook must be read and
understood both by the person in charge of assembling
the responsible for installation to perform its operation.
These operating instructions must always be available on
use site of the machine.
The safety instructions contained in this manual, whose
inobservance might cause hazards to person, are marked
with the general hazard sign, i.e.:
m
(hazard sign)
Inobservance of safety instructions may cause physical
and material damages, as well as environmental pollution.
Non-compliance with safety instructions will also lead to
the complete loss of any warranty right.
In particular, the inobservance of the above mentioned
instructions may for example result in:
failure of main machine/unit functions;
failure of maintenance procedures;
8
EN
hazard of electrical, mechanical or chemical nature.
All safety instructions contained in this manual shall be
observed, as well as any other national regulation on
accident prevention, and any internal regulation on the
use of machineries and on occupational safety.
The person in charge must verify that all maintenance,
inspection and installation works are performed by
these works, the personnel must be aware of the content
of this manual.
All interventions on the machines must be carried out
only during total standstill of the mentioned machines.
Strictly observe the shutdown procedure described in this
manual.
decontaminated.
Immediately after completion of work, all safety and
protective devices must be re-installed and/or re-enabled.
Any reconstruction or alteration of the machine must
be performed by the manufacturer before being carried
out. Original spare parts and accessories supplied by
the manufacturer ensure safety. The manufacturer is not
in any case liable for damages due to the use of non-
original spare parts!

1. DELIVERY AND STORAGE

1.1 Delivery
These submersible pumps are supplied in their own
original packing in which they should remain until
installation.
Avoid the pump to be bent when it is not packed, since
this may cause the misalignment and the damage of the
pump itself.
The loose data plate supplied with the pump should be
The pump shall not be exposed to unnecessary impacts
and crashes.
1.2

Storage and Handling

Pump: from -20°C to +60°C
The pump should not be exposed to direct sunlight.
If the pump has not been packed, it shall be stored
horizontally, adequately supported, or vertically, to
prevent the misalignment of the pump. During storage,
the pump can be supported as shown in Fig. 1.