Function And Device Overview; General Information About The Homematic System; Start-Up; Simple Operating Functions On The Device - eQ-3 HomeMatic HM-LC-Sw1-Pl-DN-R5 Bedienungsanleitung

Function and device overview

3 Function and device overview
The HomeMatic Wireless Switch Actuator 1-channel, plug adapter ena-
bles switching of connected devices via radio.
The device can be easily mounted without tools - after the device has
been plugged in, it is immediately ready for use. The wireless switch
actuator enables easy operation directly on the device. Alternatively,
multiple HomeMatic devices (e.g. HomeMatic remote controls) can be
assigned. Information about the current operating status or error mes-
sages is given be the device LED.
In connection with the HomeMatic Central Control Unit CCU2 the wire-
less switch actuator can be individually configured via the WebUI user
interface and the full range of functions can be used. The maximum
switch on and off duration as well as a delay time for switching con-
nected devices on and off can be individually adjusted.
(A) - Channel button
(B) - Device LED
24
B
A

General information about the HomeMatic system

4 General information about the HomeMatic
system
This device is part of the HomeMatic home control system and works
with the bidirectional BidCoS wireless protocol.
®
All devices are delivered in a standard configuration. The functionality
of the device can also be configured with a programming device and
software. The additional functions that can be made available in this
way and the supplementary functions provided by the HomeMatic sys-
tem when it is combined with other components are described in the
HomeMatic WebUI Manual.
All current technical documents and updates are provided in the down-
load area at www.homematic.com.
5

Start-up

5.1

Simple operating functions on the device

• Insert the wireless switch actuator into a socket.
The device is immediately ready for operation and can be taught-in to a
HomeMatic CCU (or to other HomeMatic devices).
Via the channel button (A), connected loads can be controlled (switch
on and off) with a short button press.
Before being able to use and configure your device in the HomeMatic
system, the switch actuator has to be taught-in first (see sec. „5.2 Tea-
ching-in" on page 25).
5.2

Teaching-in

Please read this entire section before starting the teach-in
procedure.
To integrate the switch actuator into your HomeMatic system and en-
able it to communicate with other HomeMatic devices (e.g. HomeMatic
25