General Information About Radio Operation; Technical Specifications - eQ-3 HomeMatic HM-LC-Sw1-Pl-DN-R5 Bedienungsanleitung

General information about radio operation

11 General information about radio operation
Radio transmission is performed on a non-exclusive transmission path,
which means that there is a possibility of interference occurring. Inter-
ference can also be caused by switching operations, electrical motors
or defective electrical devices.
The range of transmission within buildings can differ greatly
from that available in the open air. Besides the transmitting
power and the reception characteristics of the receiver,
environmental factors such as humidity in the vicinity have an
important role to play, as do on-site structural/screening
conditions.
If "secure transmission" (AES) is activated for the switch
actuator, this implies:
• increased volume of communication traffic
• actuator groups are unable to execute commands simultaneously.
Please refer to the HomeMatic WebUI Manual at www.homematic.com
for further information on secured operation.
eQ-3 AG hereby declares that this device complies with the essential
requirements and other relevant regulations of Directive 1999/5/EC.
You can find the full declaration of conformity at www.homematic.com.
12

Technical specifications

Device short description:
Supply voltage:
Current consumption:
Power consumption in standby:
Load type:
Maximum switching capacity:
Relay:
34
HM-LC-Sw1-Pl-DN-R5
230 V/50 Hz
10 A (max.)
0.6 W
ohmic load
2300 W
NO contact, 1-pole, μ contact
Radio frequency:
Switching cycle:
Receiver category:
Typ. open area RF range:
Duty cycle:
Operating mode:
Switch type:
Degree of protection:
Protection class:
Method of operation:
Withstand voltage:
Degree of pollution:
Ambient temperature:
Dimensions (W x H x D):
Weight:
Subject to technical changes.
Instructions for disposal
Do not dispose of the device with regular domestic waste.
Electronic equipment must be disposed of at local collection
points for waste electronic equipment in compliance with the
Waste Electrical and Electronic Equipment Directive
.
Information about conformity
The CE Marking is simply an official symbol relating to the free
movement of a product; it does not warrant a product's charac-
teristics.
For technical support, please contact your specialist dealer.
Technical specifications
868.3 MHz
40000 (10 A, ohmic load)
SRD category 2
300 m
< 1 % per h
S1
independently mounted switch
IP20
Type 1
2500 V
-10 °C to +35 °C
59 x 122 x 40 mm (not incl. plug)
162 g
I
2
35