Mf3 Cs Oven - OEM MF 1 Bedienungs- Und Wartungshandbuch - Ersatzteilkatalog

13) MF 3 CS OVEN
A1) Thermostat pilot lamp
A2) Thermostat adjustable from 0° to 400° C
A3) Pilot lamp for ignited oven
A4) Switch for oven ignition
13.1) Ignition of MF 3 CS oven
FIRST STARTING
Be sure that there are not foreign bodies in the baking chamber, start electric tension by a possible cut-out switch.
Turn the ingition switch (A4), let the thermostat (A2) reach a 400°C temperature and keep it approximately two/three
hours, in order to eliminate a refractory surface moisture.
FIRST PROCESSING
Turn the ignition switch (A4), let the thermostat (A2) reach the wished temperature, the thermostat pilot lamp (A1) lights
up, when the wished temperature is reached in the chamber, the pilot lamp goes out.
Here, the lower resistance cannot be cut-out like in MF1 and MF2 models.
WARNING
Since the oven id equipped with a safety thermostat, the latter completely cuts out the resistances in case of troubles.
In this case, disconnect the oven from the power supply network, disconnecting the cut-out switch. Then, contact the
technical service.
CLEANING OF THE OVEN
See chapter 9.6.
No need of particular maintenance, but the equipment should be checked by skilled personnel, every four years.
Downloaded from www.Manualslib.com
MF1 - MF2 - MF3 CS OVENS FOR GASTRONOMY AND PIZZERIA
manuals search engine
A1) Thermostat pilot lamp
A2) Thermostat adjustable from 0° to 400° C
A3) Pilot lamp for ignited oven
A4) Switch for oven ignition
25