Herunterladen Inhalt Inhalt Diese Seite drucken

Setting Up The Device; Installation - Beko HNS61210W Handbuch

Vorschau ausblenden Andere Handbücher für HNS61210W:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
5

Setting Up the Device

A
WARNING
Please read saffety instructions be-
fore setting up.
C
NOTE
Please refer to page 142 for the in-
stallation guide
WARNING
A
Failure to install the screws or fix-
ing device in accordance with these
instructions may result in electrical
hazards.

5.1 Installation

The hood is designed to be used either for ex-
hausting or filter version.
Ducting version
The cooker hood has an upper air duct B1 and an
optional rear air duct B2*, for external fumes exit.
Select the suitable air duct and apply the flange
C supplied, ensure to close the unused hole duct
with cap D* supplied if provided.
NOTE
C
In some models upper hole B1 is
supplied closed: Press firmly to de-
tach the detachable part that closes
the outlet hole and remove it.
ATTENTION!
The detachable part cannot be
A
mounted in position again. Carry
out this operation only if you are
sure of the type of installation to
make.
12 / EN
CAUTION!
In some models the rear hole duct
is not easily accessible, even when
the tap (if mounted) is removed, in
A
this case remove the plastic piece
E1 or E2 that is blocking the hole
duct, by unwinding using pliers and
cutter. Check that the filter/suction
selector (inside the cooker hood) G
is in the suction (A) position.
Filter version
In the case where it is not possible to discharge
the cooking fumes externally, the cooker hood
may be used in the filter version by fixing a carbon
filter, the fumes and vapours are recycled via the
anterior grill placed above the control panel. Check
that the filter/suction selector (inside the cooker
hood) G is in the filter (F) position.
The models with no suction motor only operate in
ducting mode, and must be connected to an exter-
nal suction device (not supplied).
The connecting instructions are supplied with the
peripheral suction unit.
The minimum distance between the supporting
surface for the cooking equipment on the hob and
the lowest part of the range hood must be not less
than 65 cm from electric and gas or mixed cookers.
If the instructions for installation for the gas hob
specify a greater distance, this must be adhered
to.
Hood / User Manual

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Hns61210bHns61210xHns61210xhHns91210x

Inhaltsverzeichnis