Herunterladen Diese Seite drucken

BEBE CONFORT ISEOS TT Gebrauchsanweisung Seite 13

Werbung

Downloaded from
www.Manualslib.com
REGLAGE DU HARNAIS - ADJUSTING THE HARNESS
manuals search engine
5 - A partir de l'arrière du siège,
faites passer les plaques
des protections de bretelles
dans les fentes du dossier.
6 - Choisissez la hauteur
de harnais désirée (A, B
ou C) et faites passer
les plaques des protections
de bretelles dans les fentes
correspondantes.
7 - Refaites passer
les bretelles à l'intérieur
des deux protections,
puis introduisez les dans
les fentes correspondantes,
vers l'arrière du siège.
Accrochez les boucles
des bretelles à la plaque.
• Pour un accès plus facile
aux fentes hautes du dossier,
mettez le siège en position
assise.
• Pour un accès plus facile
aux fentes basses
du dossier, mettez le siège
en position allongée.
8 - Avant de repositionner
la pochette,tendez
les bretelles en tirant
fermement sur la sangle
de réglage. Puis remettez
la pochette de la notice
en cachant la plaque
d'accrochage derrière
(pli de la pochette en haut).
ATTENTION : conservez
toujours la pochette dans
son logement, même
si la notice n'est pas
à l'intérieur. Son absence
pourrait provoquer
des disfonctionnements.
Avant une nouvelle
utilisation du siège vérifiez
le bon fonctionnement du
harnais.
13
5 - From behind the seat,
pass the protective plates
for the shoulder
straps through the slits
in the backrest.
6 - Select the desired height
for the harness (A, B or C)
and pass the protective plates
for the shoulder straps through
the corresponding slits.
7 - Thread the shoulder straps
back through the two chest
pads, then through the
corresponding slits towards
the back of the car seat.
Hook the shoulder straps
back onto the catch plate.
• For easier access to the top
slits in the back of the car
seat, put the car seat
in the upright position.
• For easier access
to the bottom slits in the back
of the car seat, put the car
seat in the reclined position.
8 - Before replacing the wallet,
tighten the shoulder straps
by pulling firmly
on the adjustment strap.
Then replace the instructions
wallet, concealing the catch
plate behind it (fold of wallet
at the top).
IMPORTANT: always have the
wallet in place, even
if the instructions are not inside
it. If it is not in place, this could
cause problems. Before using
the seat again check that the
harness
is working properly.
FR - EN

Werbung

loading