Lenord+Bauer GEL 211CS0 Betriebsanleitung Seite 107

Lenord+Bauer
Gear wheel signals (at around 30° it can be seen that a tooth may be damaged)
A yellow vertical line shows the actual gear wheel position and can be moved over
the entire range by slowly turning the gear wheel. The angle reference point (0°/360°)
is the position of the reference mark. The BQ value (magenta) and the Vpp value for
the sine signal (blue) at this position can also be read using this feature.
Using this function you can also accurately locate a faulty point on the measuring
scale:
Localisation of a tooth error
GEL 211CS0
Sensor calibration group
Max
ΔBQ B
ΔVpp
Min
29.6°
7 Functions of the GEL 211C
BQ
107