7 Functions of the GEL 211C
You will find explanations on this topic in the glossary
On the usage of a MiniCODER without
reference signal, appropriate configuration using
the related button is required before the mea-
surement and the number of teeth on the gear
wheel used must be entered.
Prior to the measurement, the measurement setup must be selected by actuating the
related button (Inline OFF / Inline ON).
The measurement is undertaken as soon as you press
the Start SIN/COS signal analysis button. By default a sin-
gle measurement is undertaken; however, the values
can be acquired and displayed continuously (Single/
Continuous button).
A report should not be saved with continuous measure-
ment (incorrect display).
Using the Save button you can save the results of the most recent analyses (REF,
SIN/COS, gear wheel) in a report and add a comment.
104
Sensor calibration group
Lenord+Bauer
(→ page
130).
GEL 211CS0