Replacement Of Lamp - Grundig GDS 2460 B Anleitung

3 Using the Appliance
stop. This feature is disables when
you switch between different speed
stages. If you want the appliance to
stop automatically, you need to enable
the automatic stop feature again.

3.5 Replacement of Lamp

(Figure 2)
Make the electrical connections of
the appliance. Your appliance uses
3W spot LED lamp. For replacing
the lamps, push downwards on
the holder from its behind, turn
it counter-clockwise, and take it
out downwards. Apply the above
operation in reverse to install new
lamps (Figure 2).
11
BULB
Bulb Power (W)
Holder / Socket
Bulb Voltage (V)
Size (mm)
ILCOS Code
3.6 Connected to a
Flue
Vapour is extracted
•
through
duct, which is fastened to the
connection head on the hood.
The diameter of the flue duct
•
must be the same as the
connection ring. In horizontal
settings, the pipe has to have a
slight upward slope (around 10º)
so that the air can exit the room
easily.
3.7 Using Without Flue
Air
•
through the charcoal
filter and recirculated
in the room. Charcoal
filter is used when it
is impossible to use a flue in the
house.
In flueless use, remove the flaps
•
inside the flue adapter.
Remove the oil filter. To install
•
the carbon filter, fit the filter to
the tabs by centring it on the
plastic piece on both sides of the
fan body. tighten it by turning
right or left.
Replace aluminium oil filter.
•
3
GZ 10
220 240
53 x 50
DR/F3-220-240-
GZ10-50-53
the flue
is filtered