Cleaning The Blender; Troubleshooting - Bosch MCM640604 Gebrauchsanleitung

en

Troubleshooting

Before cleaning the dicer, disassemble it:
Fig. G
■ Press out the 3 catches and remove
the slicing disc.
■ Take blade insert out of the base holder.
■ Remove food remnants from the cutting
grid using the cutting grid cleaner.
■ Clean base holder in the dishwasher.
Pre-rinse all other parts under running
water. Clean parts with a brush.

Cleaning the blender

W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean with a brush.
It is recommended to clean the blender
immediately after use. This will prevent
residue from drying on and attacking
the plastic (e.g. by essential oils in herbs).
The blender jug, lid and funnel are
dishwasher-safe.
Do not clean blade insert in the dishwasher,
but under running water. Do not leave
in water!
Tip: Pour a little water and washing-up
liquid into the attached blender. Switch
on at setting M for several seconds. Pour
out the water and rinse the blender with
clean
water.
Taking the blender apart
Fig. J
■ Upon the wings, rotate the blade insert
in an anti-clockwise direction. The blade
insert is released.
■ Take blade insert out and remove sealing
ring.
Putting the blender together
■ Apply sealing ring on blade insert.
■ Insert blade insert from below into
blender jug.
■ Firmly screw on the blade insert by
the wings in a clockwise direction. Rotate
the blade insert at least until a wing
covers the mark on the blender jug
(for position, see Fig. J-6).
24
12_MCM640604_8001028714.indb 24
Cleaning the universal cutter
W Risk of injury from sharp blades!
Do not touch universal cutter blade with
bare hands. Clean with a brush.
It is recommended to clean the universal
cutter immediately after use. This will
prevent residue from drying on and
attacking the plastic (e.g. by essential oils
in herbs). The lid is dishwasher-safe. Do not
clean jug and drive in the dishwasher, but
under running water using a brush. Do not
leave in water!
To dry, place the jug and drive
face up.
Troubleshooting
W Risk of injury!
Before rectifying a fault, pull out the mains
plug.
Important information:
The operation indicator flashes if the appli-
ance has been operated incorrectly or
the electronic fuse has tripped or the appli-
ance is defective.
Base unit
Fault:
Appliance does not work.
Possible cause:
The appliance was overloaded (e.g. tool
jammed by food) and the electronic fuse
has tripped.
Remedial action:
■ Turn rotary switch to P.
■ Pull out the mains plug.
■ Eliminate the cause of the overload.
■ Switch the appliance back on again.
Possible cause:
An attempt was made to attach the bowl or
blender to the appliance while switched on.
Remedial action:
■ Turn rotary switch to P.
■ Attach the bowl or blender.
■ Switch the appliance back on again.
03.12.2015 15:17:38