Bosch MCM640604 Gebrauchsanleitung Seite 21

If these guidelines are not observed,
the dicer, including the cutting grid and
the rotating blade, may be damaged.
If the dicer is not used as intended, is modi-
fied or is used improperly, no liability can be
assumed for any resulting damage.
Also excluded is the liability for damage
(e.g. blunt or deformed blades) which result
from the processing of unapproved food.
Important information:
When working with the dicer, use the drive
shaft supplied with the dicer (Fig. F-2).
Select operating speed according to
the food to be diced.
Low operating speed ("min"):
boiled potatoes, carrots and eggs; cucum-
bers; bananas; strawberries; melons.
Medium operating speed:
raw potatoes and carrots; soft meat
sausage (e.g. Mortadella); cheese slices,
hard cheese; peppers, tomatoes, onions;
apples, kiwis.
Caution!
When working with the dicer, never
use intermittent operation (Pulse).
Important information:
– Food must not contain any bones, pips or
other solid constituents.
– Food must not be
– frozen. Fruit/vegetables should not be too
ripe, as the juice may escape.
– Leave cooked food to cool down before
dicing it, as it will then be firmer and
the dicing result will be better.
– The length of the cubes can be influenced
by increasing or reducing the pressure
on the pusher when pushing down.
Assembling the dicer
Fig. E
■ Insert the blade insert into the base
holder. Observe recesses!
■ Insert the dicing disc into the base holder.
■ Press up the 3 catches until they lock into
position.
12_MCM640604_8001028714.indb 21
Working with the dicer
Fig. F
■ Place drive shaft for the dicer on the drive
on the base unit.
■ Attach the bowl (arrow on bowl on dot
on the appliance) and rotate as far as
possible in a clockwise direction.
■ Insert the dicer.
The arrow on the dicer and the arrow
on the bowl must be in alignment!
Dicer must be positioned fully on the drive
shaft! If required, turn the blade insert into
the correct position using the blade cover
(Fig. F-6).
■ Remove the blade cover.
■ Attach lid (match arrow on lid on dot
on bowl) and rotate in a clockwise direc-
tion.
Lid lug must be located fully in the slot
in the bowl handle.
■ Insert pusher and pusher insert.
■ Plug into the mains.
■ Set the rotary switch to the desired
setting.
■ Place the food to be diced in the feed
tube. If required, push down the pusher
by applying light pressure. If required,
chop up food beforehand.
Caution!
Empty the bowl without delay:
– after processing max. 500 g,
– before the cubes have reached the lower
edge of the dicer.
After using the appliance
■ Turn rotary switch to P.
■ Pull out the mains plug.
■ Rotate the lid in an anti-clockwise direc-
tion and remove.
■ Attach the blade cover.
■ Take dicer out of the bowl.
■ Rotate bowl anti-clockwise and remove.
■ Remove the drive shaft.
■ Remove food remnants from the cutting
grid using the cutting grid cleaner.
Dicer en
21
03.12.2015 15:17:36