Switching On And Off; Selecting The Stroke Rate; Trial Run - Parkside PFS 710 E4 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

˜ Switching on and off
Before switching on: Connect the power cord
¾
with power plug 10 to the socket .
After switching off: Disconnect the power
¾
cord with power plug 10 from the socket .
m
CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product .
m
CAUTION! RISK OF INJURY!
Before switching on the product: Ensure
u
the saw blade is not in contact with the
workpiece .
Ensure your stance is stable . Always hold
u
the product's front 14 and rear handle 9
firmly with both hands while working
(Fig . E) .
Keep your hands away from the saw
u
blade when the product is in operation .
During operation, you can choose between
instantaneous and continuous operation .
Instantaneous operation
Switching on: Press and hold the on/off
switch 12 .
Switching off:
Release the on/off switch 12 .
Continuous operation
Start: Press and hold the on/off
switch 12 . Simultaneously,
push in the switch lock 11 .
Release the on/off switch .
End: Press and then release the on/
off switch 12 . The product
goes off .
16 GB
˜ Selecting the stroke rate
Use the adjusting wheel (stroke rate) 13 to
¾
select the desired stroke rate (Fig . F):
Turning direction Stroke rate
–
+
The stroke rate can also be changed during
¾
operation .
˜ LED work light
This product is equipped with a LED work light 2
to illuminate the immediate working area to
improve visibility in poorly illuminated areas .
The LED work light 2 lights up automatically
¾
as long as the product is switched on .
˜ Trial run
NOTE
Always carry out a no-load trial run
u
before starting work and after every saw
blade replacement . Switch the product off
immediately if the saw blade is not running
smoothly, if considerable vibration occurs
or if you hear abnormal noises .
(Fig . F)
(Fig . F)
Decrease
Increase