♦
Let go of the quick-release chuck
returns to its initial position. The saw blade
is now locked.
Adjusting the footplate
RISK OF INJURY!
►
Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
♦
Adjust the footplate
depth.
♦
To do so, undo the locking lever
the footplate
to the corresponding position.
♦
Lock this position by closing the locking lever
Adjusting the pendulum stroke
♦
You can use the pendulum stroke switch
to adjust the pendular movement of the saw
blade
. You can achieve fine, clean-cut edges
without pendulum movement (setting "0").
Deactivate pendulum movement when working
on thin workpieces. You can achieve an increas-
ingly fast work rate if the pendulum stroke is
activated (setting "I").
│
GB │ CY
■
8
so that it
according to the cutting
and move
Use
Switching on and off
Switching on:
♦
First press the safety lock-out
ON/OFF switch
safety lock-out
Switching off:
♦
Release the ON/OFF switch
Adjusting the rotational speed
Press the ON/OFF switch
Increasing the pressure increases the speed.
NOTE
►
The integrated motor brake ensures rapid
stoppage.
Guiding the sabre blade safely
To adapt to the workpiece and for safe placement,
the footplate
can be swivelled. It must always be
in contact with the workpiece when the appliance
is running.
.
Practical advice on sawing
♦
Check the material to be worked to make sure
that all foreign objects have been removed,
e.g. nails, screws, etc.
♦
Ensure that the ventilation slits
covered.
♦
Switch the appliance on before moving it
towards the material to be worked.
♦
Switch the appliance off immediately if the saw
blade
jams.
Open up the sawn gap using a suitable tool
and pull out the sabre saw.
■
Use the appropriate saw blade
rate for the material to be worked.
■
Saw blades optimised for your sabre saw are
available from retail stores in different lengths
for various purposes.
■
Saw the material at a constant speed.
and then the
. Afterwards, release the
.
.
lightly for a low speed.
are not
and stroke
PSSA 20-Li A1