Reciprocating Saws Safety Warnings - Parkside PFS 710 E4 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

2) Do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot be
controlled with the switch is dangerous and
must be repaired .
3) Disconnect the plug from the
power source and / or the battery
pack from the power tool before
making any adjustments, changing
accessories, or storing power
tools. Such preventive safety measures
reduce the risk of starting the power tool
accidentally .
4) Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained users .
5) Maintain power tools and
accessories. Check for misalignment
or binding of moving parts,
breakage of parts and any other
condition that may affect the power
tool's operation. If damaged, have
the power tool repaired before
use. Many accidents are caused by poorly
maintained power tools .
6) Keep cutting tools sharp and
clean. Properly maintained cutting tools
with sharp cutting edges are less likely to
bind and are easier to control .
7) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different from
those intended could result in a hazardous
situation .
8) Keep handles and grasping surfaces
dry, clean and free from oil and
grease. Slippery handles and grasping
surfaces do not allow for safe handling and
control of the tool in unexpected situations .
Service
Have your power tool serviced by
1)
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained .
˜ Reciprocating saws safety
warnings
Hold the power tool by insulated
1)
gripping surfaces when performing
an operation where the accessory
tool may contact hidden wiring.
Accessory tools contacting a "live" wire may
make exposed metal parts of the power tool
"live" and could give the operator an electric
shock .
GB 11