Water Drainage - Electrolux WAGL3E200 Benutzerhandbuch

• Connect the water inlet hose to the
cold water tap with 3/4 thread.
CAUTION!
Make sure that there are no leaks
from the couplings.
Do not use an extension hose if
the inlet hose is too short. Contact
the service centre for the replace-
ment of the inlet hose.
Water-stop device
The inlet hose has a water stop device.
This device prevents water leaks in the
hose because of its natural ageing. The
red sector in the window «A» shows this
fault .
If this occur, close the water tap and con-
tact the service centre to replace the
hose.
O O O
45 45 45
O O O
20 20 20

16.5 Water drainage

There are different procedures to connect
the drain hose:
With the plastic hose guide.
• On the edge of a sink.
Make sure that the plastic guide cannot
move when the appliance drains. At-
tach the guide to the water tap or the
wall.
• To a stand pipe with vent-hole.
ENGLISH 27
A