Electrolux WAGL3E200 Benutzerhandbuch Seite 23

Problem
The appliance
does not drain the
water.
The appliance
door is open or not
closed correctly.
The anti-flood de-
vice is on.
The spin phase
does not operate.
The programme
does not start.
There is water on
the floor.
Possible cause
The water pressure is
too low.
The water drain hose is
damaged.
The filter of the drain
pump is blocked.
The connection of the
water drain hose is not
correct.
A washing programme
without the drain phase
is set.
The function Rinse &
Hold is on.
The spin phase is off.
The filter of the drain
pump is blocked.
Balance problems with
the laundry load.
The mains plug is not
connected in the mains
socket.
Blow out fuse in the
household fuse box.
You did not press button
.
4
The delay start is set.
The Child Lock function
is activated.
Leakages from the cou-
plings of the water ho-
ses.
Possible solution
Contact your local water authori-
ty.
Make sure that the water drain
hose has no damages.
Clean the filter of the drain pump.
Refer to 'Care and cleaning'.
Make sure that the connection is
correct.
Set the drain programme.
Set the drain programme.
Close the door correctly.
• Disconnect the appliance.
• Close the water tap.
• Contact the service centre.
Set the spin programme.
Clean the filter of the drain pump.
Refer to 'Care and cleaning'.
Adjust manually the items in the
tub and start the spin phase
again.
Put in the mains plug.
Replace the fuse.
Press button 4 .
To start immediately the pro-
gramme, cancel the delay start.
Deactivate the Child Lock func-
tion.
Make sure that the couplings are
tight.
ENGLISH 23