Electrolux WAGL3E200 Benutzerhandbuch Seite 20

20 www.electrolux.com
2.
Pull the dispenser out.
3. Remove the top part of the liquid ad-
ditive compartment.
4. Clean all the parts with water.
5. Clean the dispenser recess with a
brush.
6. Put back the dispenser in the recess.
14.7 Drain pump
Regularly examine the drain pump
and make sure that it is clean.
Clean the pump if:
• The appliance does not drain the water.
• The drum cannot turn.
• The appliance makes an unusual noise
because of the blockage of the drain
pump.
• The display shows an alarm code be-
cause of the problem with water drain.
1
2
WARNING!
• Disconnect the mains plug from
the mains socket.
• Do not remove the filter while
the appliance operates. Do not
clean the drain pump if the wa-
ter in the appliance is hot. The
water must be cold before you
clean the drain pump.
Cleaning the drain pump:
1. Open the drain pump door.
2. Pull the flap out to remove it.
3. Put a container below the recess of
the drain pump to collect the water
that flows out.
4. Press the two levers and pull forward
the drainage duct to let the water flow
out.
5. When the container is full of water,
put the drainage duct back again and
empty the container. Do steps 4 and
5 again and again until no more water
flows out from the drain pump.
6. Pull back the drainage duct and turn
the filter to remove it.