Electrolux WAGL3E200 Benutzerhandbuch Seite 21

1
2
7.
Remove fluff and objects from the
pump.
8. Make sure that the impeller of the
pump can turn. If this does not occur,
contact the service centre.
9. Clean the filter under the water tap
and put it back in the pump into the
special guides.
10. Make sure that you tighten correctly
the filter to prevent leakages.
11.
Put the flap back and close the drain
pump door.
1
14.8 The inlet hose filter and the
valve filter
It could be necessary to clean the filters
when:
• The appliance does not fill with water.
2
• The appliance fills with the water for a
long time.
• The indicator of button
the display shows the related alarm.
Refer to 'Troubleshooting'.
WARNING!
Disconnect the mains plug from
the mains socket.
Cleaning the water inlet filters:
1. Close the water tap.
2.
Remove the water inlet hose from the
water tap.
3. Clean the filter in the inlet hose with a
stiff brush.
4. Remove the inlet hose behind the ap-
pliance.
5. Clean the filter in the valve with a stiff
brush or a towel.
6. Install again the inlet hose. Make sure
that the couplings are tight to prevent
leakages.
20°
7. Open the water tap.
ENGLISH 21
4 flashes and
45°