Connection Configuration; Safety Advice - Cedes cegard/Lift LX/LY Installations- Und Bedienungsanleitung

cegard/Lift LX/LY
7.

Connection configuration

Important safety notice:
The units should only be connected when de-energized!
K1 - K2 Emergency stop alarm detector
K3 - K4 Contact feedback
contactor. These connections should be
bypassed if an external contactor is not
used.
K5 - K6 Contact feedback for external safety circuit
contactor. These connections should be
bypassed if an external contactor is not
used.
K7 Internal call signal 1, 12 ... 265 VAC / DC
K8 Internal call signal 2, 12 ... 265 VAC / DC
K9 Internal call signal 3, 12 ... 265 VAC / DC
K10 Internal call signal 4, 12 ... 265 VAC / DC
K11 Internal call signal 5, 12 ... 265 VAC / DC
K12 Internal call signal 6, 12 ... 265 VAC / DC
K13 Internal call signal 7, 12 ... 265 VAC / DC
K14 Internal call signal 8, 12 ... 265 VAC / DC
K15 Internal call signals, common potential
K16 - 17 Option 1 (not used)
K18 - 19 Option 2, 12 ... 380 VAC / DC*
K20 - 21 Flush position, 12 ... 380 VAC / DC*
K22 - 23 Override delay
12 ... 380 VAC / DC*
K24 - 25 Latch In, 12 ... 380 VAC / DC*
K26 - 27 Latch Out (Relay-closing contact)
K28 - 29 Safety circuit 1: The circuit is closed if no
error is evident and the system has been
started ("Safety circuit LED" illuminates),
isolated.
K30 - 31 Safety circuit 2, otherwise as safety circuit 1
K32, K33 230 VAC, phase / PEN conductor
K34 Protective earth
*Note polarity when actuating with direct voltage (see
also Chapter 5.4)

SAFETY ADVICE

Overcurrent protection shall be provided
according to DIN EN 60204-1:2019-06 (see
chapter 7).
The electrical equipment shall be wired
according to DIN EN 60204-1:2019-06.
© CEDES | V 2.8
for external latch
Figure 10: Connection terminals plug-in system controller
English
11