Cegard/Lift Lx With Latch Contactor; Cegard/Lift Ly With Latch Voltage Rectifier - Cedes cegard/Lift LX/LY Installations- Und Bedienungsanleitung

cegard/Lift LX/LY
7.1

cegard/Lift LX with latch contactor

The LX version is fitted with a standard contactor with positive-action contacts, allowing the connection of larger latch
motors or latch solenoids. The following circuit diagram clearly illustrates the connection:
Plug-in system
controller
5
Check 1 Riegel
K3
6
Check 2 Riegel
K4
4
Riegel Out
K27
Riegel Out
K26
P
K32
K33
N
PE
K34
Figure 11: Latch contactor cegard/Lift LX
7.2

cegard/Lift LY with latch voltage rectifier

The LY version is fitted with a standard rectifier, allowing the connection of direct current latch motors or latch solenoids
(from 180 VDC). The following circuit diagram clearly illustrates the connection:
The connection is supplied at terminals K40 and K42 with 230 VAC 50 Hz mains power. A DC latch solenoid not exceeding max.
2 A power input can be actuated at the rectifier outputs (±).
Plug-in system controller
Check 1 Riegel
K3
Check 2 Riegel
K4
Riegel Out
K27
Riegel Out
K26
P K32
N
K33
PE
K34
Figure 12: Latch voltage rectifier cegard/Lift LY
12
A1 21 1 3
A2 22 2 4
2
1
3
B&W
yellow-green
Voltage rectifier
~
~
~
4
~
2
1
3
B&W
yellow-green
The connection is supplied at terminals K40 and K42
with 230 VAC 50 Hz mains power.
A latch signal up to 16 A / 380 VAC can be
connected to terminals K44 und K45.
Connector
A 3-phase motor (3*380) can also be actuated
clamps
with little rewiring!
B&W
K44
5
6
B&W
K45
P
K40
K41
N
K42
K43
PE
Connector clamps
P
K40
K41
N
K42
K43
PE
Connection diagram
Both bypassing jumpers should be removed if
another latch voltage is desired. The required
voltage can be supplied from K40 and K43. Note
the contacts' maximum permitted load currents.
Connection diagram
English
© CEDES | V 2.8