Main Operating Parts Of The Machine - Corghi A 2030 Betriebsanleitung

WARNING
When working with the machine it is strongly recommended to avoid using equipment
or tools not manufactured by CORGHI.
Figure 7 shows the positions assumed by the operator during the various stages of work
with the machine.
A Bead breaker
B Tyre demounting and mounting
C Inflation area.
WARNING
The tower tilting operation must be carried out from work position C (fig.7), keeping
your hands well away from all moving parts of the machine.
WARNING
To stop the machine in an emergency:
- unplug from the electrical supply;
- isolate the air supply network by disconnecting the shut-off valve (rapid insert).
MAIN OPERATING PARTS
WARNING
Get to know your machine: the best way to prevent accidents and obtain top perform-
ance from the machine is to ensure that all operators know how the machine works.
Learn the function and location of all commands.
Carefully check that all the commands on the machine are working properly.
To avoid accidents and injury, the machine must be installed properly, operated cor-
rectly and serviced regularly.
Fig.8
1 Vertical slide movement cylinder (not present in the A 2005).
2 Locking button(not present in the A 2005): 3-position button
A Up
B Down
C Locked
3 Vertical slide / swing arm (to position the mount/demount head).
4 Mount/demount head (for fitting and removing tyre).
5 Tilt tower.
6 Sliding clamp (secures wheel to table top).
7 Sliding clamp table (rotary platform supporting the wheel).
8 Tower (5) tilt pedal (2-position pedal to operate tower tilt) (not present in the A
2005)
A 2030 - A 2025 - A 2020 - A 2015 - A 2005 operator's manual
OF THE MACHINE
GB
43