Unpacking / Assembly - Corghi A 2030 Betriebsanleitung

ATTENTION
Keep the packing material intact for possible future transport of the machine.

UNPACKING / ASSEMBLY

WARNING
Take the utmost care when unpacking, assembling, and setting up the machine as
described in this heading.
Failure to observe these instructions can lead to damage to the machine and injury to
the operator or other persons.
- Remove the upper part of the packing and make sure that the machine has not suffered
damage in transit; identify the points at which the machine is anchored to the pallet.
- The machine comprises five main sections (fig.1):
1 tower
2 tower guard
3 box with pressure gauge
4 air tank
5 cabinet
- After removing the tower 1, it is advised to place it in a horizontal position to prevent
it from falling and getting damaged.
- Take off the side cover.
- Insert the air hose G fig.2 into hole A behind the tower tilt cylinder.
- Assemble the tower 1, insert pin B into hole C and lock with screw and washer D.
- Insert pin E into hole F and into U-bolt F1 on the tower tilt cylinder and lock with ring M.
- Connect hose G to the intermediate connection linked to the tower-lifting cock H.
- Fit the box with pressure gauge 3 on to the tower 1 and lock with screw and washer S.
- Fit the tower guard 2 and lock with screws and washers L.
- Insert the tank 4 outlet into hose Q. Fix the tank 4 to the machine with nuts and washers
R and tighten clamp O on hose Q (T.I. version only).
- Open the bead break arm Z.
- Insert the spacer pad U on to the bead break cylinder pin V, re-close the bead break
arm by passing the bead break cylinder pin back through the adjustable outlet.
- Nut T is to be screwed on to bead break cylinder pin V only when the machine is in-
stalled and hooked up to the compressed air line. Tighten nut T until P is 3-4 mm. For
the A2030 only, tighten the nut and locknut until P is 20 mm.
- After removing the tower 1, it is advised to place it in a horizontal position to prevent
it from falling and getting damaged.
- Take off the side cover.
36
A 2020 - A 2025 - A 2030
A 2030 - A 2025 - A 2020 - A 2015 - A 2005 operator's manual
A 2015